ZS-010FT Universal Shaft Pin 1.5mm for ZS-010TPA Yokomo  [ZS-010TPA]

Service pin for universal shaft upkeep

This Yokomo ZS-010TPA replacement is an RC-scale universal shaft joint pin designed for maintenance and low-friction rotation of the universal shaft assembly. The part is supplied as a 1.5mm pin intended to restore smooth coupling where the original pin shows wear, and to reduce binding in the driveline during light-duty runs and setup checks.

Fit and role: the pin is a service item used to retain the low-friction joint on the universal shaft, helping to maintain predictable drivetrain behaviour after routine teardown and cleaning. It is suited to hobby-scale RC models that use the ZS-010FT joint form factor and related DP-series mounting arrangements listed below.

Supported chassis: DP-DP7C / DP-DP8 / DP-GR35 / DP-UF86A / DP-M786A / DP-HKS86A / DP-MKXA / DP-C33A / DP-SC430A / DP-TY180A / DP-JZX2A / DP-BNAA / DP-SDA / DP-EVXA / DP-DKPA / DP-BS15A / DP-REA7A / DP-DM13A / DP-ZCRA / DP-TYS15A / DP-BL34DA / DP-PS13A / DP-JZZ30A / DP-DR86A / DP-REAA / DP-ORCZ33A / DP-JZXA / DP-HKSA / DP-180SXA / DP-FC3SA / DP-S15A / DP-AE86A / MRTC-SD9 / MRTC-86.

Installation notes: the pin replaces the worn shaft pin in the universal joint, so basic disassembly of the joint is required. Use correct 1.5mm alignment when seating the pin, check free rotation after reassembly, and verify clearance at the joint during slow inspections to avoid binding.