Zero Cero Rear Lower Suspension Arm O-3CP016R by 3Racing  [FP-O-3CP016R]

Rear lower arm for Zero Cero fitment

This single rear lower suspension arm is an aftermarket replacement intended for the 3Racing Zero Cero chassis, supplied by Factory Pro as model O-3CP016R. It restores the rear lower arm when the original is worn or damaged and provides a direct like-for-like replacement for routine maintenance.

The arm locates the rear hub relative to the chassis and influences camber and toe response under load, so it directly affects suspension geometry and handling balance. Use it when you need consistent setup repeatability or a straightforward swap for damaged parts.

Installation follows the common procedure for touring-style 1/10 scale rear lower arms: remove the wheel and hub carrier as needed, swap the arm while retaining factory pins and hardware, then verify alignment and free suspension movement. Standard hobby hex drivers and pliers are sufficient.

Compatibility: Intended for 3Racing Zero Cero chassis, rear lower arm position only, sold as 1 pcs.