YZ-W91TS Graphite Main Chassis (2.5mm) for YZ-W91 and YZ-W91TS - Yokomo YZ-002GW1  [YZ-002GW1]

Yokomo YZ-002GW1 Graphite Main Chassis (2.5mm) for Works\\\'91 TeamSpec
Price:
CAD$135.32
Brand:
Yokomo
Model:
YZ-002GW1
GTIN:
3888
Condition:
Brand New
Write a review

2.5mm graphite chassis for YZ-W91TS builds

The Yokomo YZ-002GW1 main chassis is a 2.5mm graphite plate made for the YZ-W91TS platform. As a replacement main plate, it emphasizes structural rigidity and consistent flex that influence handling and tuneability. The flat layout preserves factory mounting points and cutouts so geometry remains unchanged while allowing precise adjustments to balance and suspension response.

Fitment is direct on a standard YZ-W91TS or YZ-W91 layout using the original mounting hardware. When swapping the chassis, align the motor mount, servo and battery tray before applying final torque to fasteners. Even small changes in chassis stiffness will alter weight transfer and steering feedback, so expect gradual handling changes when moving between materials or thicknesses.

Specifications

  • Item Main chassis
  • Material Graphite
  • Model Number YZ-002GW1
  • Compatibility YZ-W91TS, YZ-W91

This 2.5mm graphite main chassis fits YZ-W91TS and YZ-W91 builds to refine chassis rigidity and tuning consistency without moving mounting points.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the YZ-002GW1 bolt straight into my YZ-W91TS?

Yes. The YZ-002GW1 uses the stock mounting pattern for YZ-W91TS and YZ-W91 chassis, so it installs with the original screws and brackets.

Do I need different hardware to fit this plate?

No special fasteners are required. Reuse the factory screws and mounting hardware to preserve geometry and alignment.

How will a 2.5mm graphite plate change handling?

A 2.5mm graphite chassis is stiffer than thinner plates, reducing unwanted twist and improving steering consistency, though it may lower compliance. Adjust suspension settings incrementally after fitting.

Any checks after installation I should do?

Verify all mounting point alignment and retorque fasteners after initial runs. Inspect edges for contact with wiring or electronics and correct as needed.

Copyright © 2008-2026 rcjaz.ca All rights reserved