This is an RC rear shock shaft designed specifically for the 2WD racing truck YZ-2T. The pack contains two pieces sized for X33 shock assemblies and specifies a 3.3mm shaft diameter. It is intended as a direct replacement to address bent or worn rear shock pistons on YZ-2T-series vehicles.
The component simply restores straightness and smooth piston movement inside X33 shocks so damping remains consistent during setup changes. Because the shaft diameter is 3.3mm, it matches shocks built to X33 specification and should be checked alongside shock pistons and bushes when servicing the rear end.
Installation is a standard shock service task: strip the rear X33 shocks, remove the existing shaft, fit the replacement shaft, then rebuild with fresh shock oil and seals as needed. After reassembly, confirm shaft alignment and free travel and recheck for any play following a short test run.
Copyright © 2008-2026 rcjaz.ca All rights reserved