YZ-2T Graphite Front Shock Tower Z2-017TA by Yokomo  [Z2-017TA]

Yokomo Z2-017TA Graphite front shock tower for YZ-2T
Price:
CAD$21.78
Brand:
Yokomo
Model:
Z2-017TA
GTIN:
0639342195367
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Suspension Parts category
Write a review

YZ-2T Front Shock Tower Fitment

This graphite front shock tower from Yokomo is an RC-scale replacement part for the YZ-2T 2WD racing truck platform. It is produced in graphite to give a measured increase in front-end stiffness while keeping weight low. The item is supplied as a single front-position tower and is identified by model number Z2-017TA.

The tower mounts at the front shock assembly and upper bulkhead area on compatible B-YZ2T chassis configurations. As a direct-replacement it retains the original mounting geometry so existing hardware and shock assemblies used on the YZ-2T front end will fit without modification.

For installation, fit this tower using the factory mounting points, then recheck shock alignment and preload. Graphite will change front stiffness versus softer composites, so install the part, run a controlled test, and then make incremental spring or damping adjustments to dial in handling.

Specifications

  • Item: Graphite front shock tower
  • Material: Graphite
  • Model Number: Z2-017TA
  • Compatibility: B-YZ2T chassis (YZ-2T)

Compatibility

  • B-YZ2T

Pick this tower when you need a direct-replacement graphite option for front-end setup on YZ-2T based B-YZ2T layouts, and validate handling changes with step-by-step tests.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I install the Z2-017TA on a B-YZ2T chassis?

Remove the existing front tower hardware, align the Z2-017TA with the factory mounting holes on the upper bulkhead and front shock assembly, then secure using the original screws. Confirm shock shaft alignment after fitting.

Do I need different screws to mount this tower?

No special screws are required for typical B-YZ2T installations; the tower is designed to accept the stock fasteners that secure the original YZ-2T front tower.

Will the Z2-017TA affect shock geometry?

The Z2-017TA preserves factory mounting points, so basic shock geometry remains unchanged. Any handling differences will come from the tower material altering front stiffness, not from altered mounting locations.

Where is the model number located?

The part is listed as Yokomo Z2-017TA and sold as a graphite front shock tower intended for YZ-2T platforms.

Copyright © 2008-2026 rcjaz.ca All rights reserved