YZ-2T Front Sway Bar Wire Set (3 sizes) - Z2-412FTA Yokomo  [Z2-412FTA]

Yokomo Z2-412FTA Front Sway Bar set (3sizes) for YZ-2T
Price:
CAD$20.16
Brand:
Yokomo
Model:
Z2-412FTA
GTIN:
0639342195954
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Suspension Parts category
Write a review

YZ-2T front stabilizer components

This front stabilizer (sway bar) kit is built for RC YZ-2T racing trucks. The package contains three interchangeable wire options between 1.3mm and 1.5mm so you can step the front roll stiffness and refine corner entry and mid-corner weight transfer.

Installation note: the kit replaces the stock front stabilizer link or wire on the YZ-2T front assembly. Swap to a thicker wire to raise roll resistance or a thinner wire to lower it. This item is supplied as an aftermarket chassis tuning accessory only.

Compatibility

  • B-YZ2T
  • B-YZ2DTM3
  • B-YZ2CAL3
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do the three wire sizes change handling on the YZ-2T?

Thicker wires increase front roll stiffness which tends to reduce body roll and can lessen understeer at corner entry; thinner wires soften roll stiffness and can make the front more willing to bite. Use incremental swaps to find the desired balance.

What is the recommended process for swapping the wire?

Remove the existing stabilizer wire or link from the front assembly, fit the replacement wire of your chosen diameter, and re-secure any retaining hardware. Check alignment and clearance after installation before running.

Are special tools required to fit the sway bar?

Basic hobby tools such as pliers and the correct hex drivers or screwdrivers for your YZ-2T hardware are normally sufficient. Take care to avoid overstressing linkage pins during changeover.

Copyright © 2008-2026 rcjaz.ca All rights reserved