YZ-2T Battery Holder, Radio Tray & Spur Gear Cover - Z2-118TA by Yokomo  [Z2-118TA]

Yokomo Z2-118TA Battery holder/Radio tray/Spur gear cover for YZ-2T
Price:
CAD$22.65
Brand:
Yokomo
Model:
Z2-118TA
GTIN:
0639342195480
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Chassis Parts category
Write a review

YZ-2T Battery Tray and Spur Protection

A compact resin replacement set for the 2WD YZ-2T racing truck, comprising a battery holder, radio tray and spur gear cover. The matched components are supplied to replace damaged plastic parts or to serve as spare pieces for routine track maintenance.

Emphasis is placed on direct-fit compatibility with the supported YZ-2T variants. These resin parts are designed to secure the battery pack, accommodate the receiver and small electronics, and shield the spur gear area from dirt and debris.

During installation, confirm alignment with the chassis mounting points and fasteners, and check for any interference with the motor and spur gear mesh before final tightening. These parts are intended for RC-scale use, repair, and setup adjustments.

Specifications

  • Item: Battery holder, radio tray and spur gear cover set
  • Material: Resin
  • Model Number: Z2-118TA
  • Compatibility: B-YZ2T / B-YZ2CAL3 / B-YZ2DTM3

Compatibility

  • B-YZ2T
  • B-YZ2CAL3
  • B-YZ2DTM3

This Z2-118TA kit provides a cost-effective spare solution for YZ-2T drivers who want to swap out worn or broken plastic parts quickly and keep the truck ready for the next run.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which YZ-2T chassis use this Z2-118TA set?

The set fits the listed chassis lines: B-YZ2T, B-YZ2CAL3 and B-YZ2DTM3 as direct replacements for the original plastic pieces.

What are the resin parts like in terms of toughness?

The components are made from resin, offering solid rigidity for typical RC use. Inspect after heavy impacts and replace any cracked pieces to avoid failure during running.

Any tips to ensure proper fit during installation?

Verify that each part lines up with the chassis mounting bosses and hardware, confirm spur gear clearance with the motor, and tighten screws incrementally to prevent stressing the resin.

Will these parts change my setup or handling?

These pieces restore original mounting points and protection, helping maintain consistent battery placement and spur gear coverage so setup and on-track behavior stay repeatable.

Copyright © 2008-2026 rcjaz.ca All rights reserved