This rear universal shaft assembly is produced for the 2WD off-road YZ-2 range and links the rear differential output to the wheel hubs. It uses a C-clip style joint for straightforward retention and consistent rotational transfer during typical off-road RC running.
Designed as a direct-fit replacement, the assembly preserves the correct geometry to maintain suspension and drivetrain alignment across YZ-2 variants. Replace worn shafts or fit after an impact to recover smooth driveline operation.
Installation notes: the part fits into the existing rear driveline locations on compatible chassis and may require removal of the rear hub/axle pieces and differential output to access the universal joint. After fitting, verify alignment and free play, and re-check drive angles through full steering and suspension travel.
Copyright © 2008-2026 rcjaz.ca All rights reserved