YZ-2 Rear Universal Drive Shaft for YZ-2CA - Z2-010R2 by Yokomo  [Z2-010R2]

Rear driveshaft assembly built for YZ-2 upkeep

This scaled rear universal drive shaft is made for the 2WD off-road YZ-2 platform. The shafts use a C-clip joint for retention and the pack contains the pair needed to replace a worn rear driveshaft set. The item is intended for routine maintenance and replacement on race or practice cars rather than as a performance upgrade.

Compatibility is limited to the B-YZ2CA and B-YZ2DT chassis variants within the YZ-2 family; confirm your chassis code before ordering. The shafts act as the rotating connection in the rear drivetrain and will influence drivetrain smoothness and traction feedback.

Installation notes: fit the shafts with C-clips fully seated and clear of debris, check clearance with suspension travel and spur gear mesh, and inspect associated ball bearings and hubs for wear when replacing shafts. Perform routine checks after a few runs to confirm clip retention and absence of unexpected play.