YS Engine YSF1258 Throttle Stop Screw for RC Model Engines  [YSF1258]

Mechanical throttle stop for stable idle and travel control

This YS Engine YSF1258 throttle stop screw is an RC-scale replacement part designed to control the mechanical end point of a model engine throttle. It serves as the adjustable limit that defines idle position and maximum closed throttle, helping to stabilize idle and prevent accidental overtravel of the throttle arm.

Constructed as a threaded stop adjuster, the part replaces the factory stop screw in throttle linkages or carburetor bodies that accept a threaded limiter. In practice it provides a predictable contact surface for setting the physical travel of the throttle arm without electronic intervention.

Installation is straightforward for experienced model technicians: remove the existing stop screw, thread the YSF1258 into the same location until it contacts the throttle arm at the desired idle position, then fine-tune by small increments to balance idle speed and responsiveness. Because this is a mechanical limit, gradual adjustments and engine testing on the bench are recommended to avoid excessive idle or unexpected throttle closure.

Tuning notes: use the stop to set a reliable baseline idle before adjusting needle valves or ignition timing in glow setups, or before electronic tuning of throttle endpoints on servo-controlled systems. The stop screw is a simple tool for repeatable mechanical limits during setup and race-day adjustments.