Yokomo YOKZSGWB Gokuraku Off-Road Rear Wing for Off-Road RC Cars  [YOKZSGWB]

Gokuraku rear wing summary

This Yokomo YOKZSGWB Gokuraku Off-Road Wing is an RC-scale rear body wing built for off-road model cars and common hobby shells, aimed at bashing and track setup use. The description focuses on practical fitment and handling effects rather than marketing claims.

In use, the wing adds a rear aerodynamic surface that changes downforce and airflow behind the body. On loose or low-traction surfaces it can alter rear grip and pitch behavior, giving tuners an additional setup parameter alongside suspension and weight distribution. The influence scales with wing angle and mounting height, so small adjustments are typically most informative during setup.

Fitting the wing is straightforward on bodied off-road models: position the wing over existing body posts or mark and drill mounting holes where the shell and mounts allow, secure with common hobby screws, and trim the shell if clearance is required. Verify the wing does not contact tyres, suspension travel, or antennae through full articulation. If shaping the shell is necessary, cut incrementally and retest to preserve aerodynamic intent.

Setup tips: use the wing to refine rear-end stability rather than as the main source of traction. Change the mounting angle in small steps and test lap times or handling in the same conditions after each change. Combine wing tweaks with suspension and weight adjustments to isolate its effect.