Yokomo YZ-2 Rear Suspension Mount Spacer for fine arm height adjustment - Yokomo Z2-300RSA  [Z2-300RSA]

Precise spacer for YZ-2 rear mounts

This is an RC-scale rear suspension mount spacer designed for the Yokomo YZ-2 family. The spacer is intended to be used when you change the position of the plastic rear suspension mount pieces; inserting the spacer allows smaller, incremental changes to the rear suspension arm height without modifying the original mounting parts.

Use this part as a fine-tuning tool when setting rear roll center, ride height, or to equalise geometry after swapping mount plates. It does not replace the plastic mount pieces but stacks with them to provide a controlled offset. Keep adjustments small and verify handling on a test run after each change.

Installation is straightforward: remove or loosen the rear mount as required, place the spacer between the plastic mount layers at the selected location, then reassemble and check alignment. Because this part is for fine adjustments, make incremental changes and re-check suspension travel and arm clearance before full-speed runs.