Yokomo YOKZCTB27 27mm Titanium Turnbuckle Pair for 1/10 Scale  [YOKZCTB27]

27mm titanium link for 1/10 scale RC

This pair of 27mm titanium turnbuckles is made as adjustable tie-rod links for steering and suspension setup on 1/10 scale RC models. Supplied as two pieces, the turnbuckles allow fine adjustments between ball ends and rod ends so you can dial toe, correct minor camber linkage geometry, and trim steering throw without swapping fixed-length rods.

Installation is straightforward for anyone used to standard turnbuckle links: remove the old link, match left- and right-hand threads, screw in until you hit the nominal length, then fine-adjust both ends so thread engagement is equal. Lock any existing hardware on your ends and check free movement through the steering knuckles and suspension pick-up points before a test run.

Tuning use: change the length to introduce small toe-in or toe-out, fix asymmetry, or tweak steering centering. The titanium construction lowers mass at the outer linkage and helps prevent corrosion, keeping geometry stable. Inspect ball cups and mating hardware for wear and compatibility, and recheck settings after the first track session.