Yokomo YOKSD415S10 Aluminum Front Steering Block 10° King Pin Offset for Drift  [YOKSD415S10]

Aluminum steering block for drift setups

This aluminum front steering block is an RC-scale replacement part created for drift setups that need a 10 degree king pin offset to change front steering geometry. The part emphasises the steering pivot location and how that pivot alters steering angle and response when tuning for drifting.

Intended strictly for RC drift use, this is a tuning component rather than a full steering assembly. Fitment replaces the current front steering block or king pin carrier on compatible drift hubs using the vehicle's original fasteners, and it is advisable to perform alignment checks after installation to confirm king pin orientation and wheel toe.

From a setup perspective, a 10 degree king pin offset repositions the steering pivot relative to the wheel plane, often increasing available steering angle and modifying self-centering characteristics; you may need to adjust toe and steering link geometry to dial in handling for your specific drift style.

As a targeted tuning item, this aluminum steering block gives a defined 10 degree king pin offset for pilots refining front-end behaviour on RC drift chassis, and should be used alongside careful alignment and setup checks.