Yokomo YOKSD300R25 Aluminum Rear Suspension Mount (Rear, 2.5 degree)  [YOKSD300R25]

Aluminum rear suspension mount with 2.5 degree angle

This Yokomo YOKSD300R25 aluminum rear suspension mount is an RC-scale replacement part that provides a fixed 2.5 degree rear mounting option for rear suspension setups, offering a hardened mounting point where a stiffer, repeatable mounting surface is required.

The part is machined from aluminum to increase structural stiffness compared with common plastic mounts, and it is intended to be used in model car rear suspension mounting locations that accept a dedicated angled mount. The 2.5 degree designation identifies the built-in mounting angle, which gives builders a consistent geometry choice when adjusting rear suspension characteristics.

Installation is straightforward for users familiar with suspension component swaps: confirm the mount orientation and secure it using the chassis' existing rear suspension fasteners or the hardware already intended for a rear mount. Verify alignment and range of motion after installation to ensure the new mount does not interfere with nearby components.

Tuning role: use this mount as a deterministic option when testing rear-end geometry changes, comparing results against stock components, or when a metal mounting surface is preferred for repeatability during setup changes.