This RC ball connector secures a king pin into an aluminum steering block using an ISO 3mm screw. The button head keeps the ball stud profile compact to minimize contact with nearby suspension and steering parts on touring and on-road models.
Fitment depends on the steering block screw type and hole spacing; this part is made for blocks that accept an ISO 3mm screw thread. Make sure the block will accept a button head screw and that the ball seat geometry matches your linkage before fitting.
Installation is best handled by experienced hobbyists: use the specified ISO 3mm screw, fasten the ball stud to the steering block, and confirm the ball moves freely without excess play. Re-check ball-seat contact and re-torque after initial runs, and replace the ball if you see wear or slack developing.
As a tuning item, this low-profile ball joint can help reduce linkage bind and deliver more consistent steering when paired with correctly shimmed geometry and secure king pin assemblies.
Copyright © 2008-2026 rcjaz.ca All rights reserved
