Yokomo YOKIB414KB1 11mm Hex Kingpin Ball for Aluminum Steering Block Seats (4pcs)  [YOKIB414KB1]

11mm Hex Kingpin Ball for Precision Steering

This 11mm hex kingpin ball from Yokomo is an RC-scale replacement ball connector intended for use with aluminum steering blocks. The package includes 4pcs suitable for replacing worn ball ends or refreshing a steering linkage assembly without changing the steering block itself.

Compatibility is limited to setups that accept an 11mm hex kingpin ball into an aluminum steering block seat, so verify the steering block ball seat and hex engagement prior to fitting. This part serves as the direct connection point in the steering linkage and will influence steering feel and geometry during tuning.

Fitting guidance: remove the old ball connector from the steering block, check hex orientation and engagement, then fit the new 11mm hex ball ensuring full seating. Use the correct hex driver for mating hardware and avoid over-tightening to prevent thread or seat damage. Inspect for lateral play after installation and recheck during initial runs.

The part is intended for RC model use only and is presented as an accessory component for steering assembly maintenance and tuning.