Yokomo YOKBM206W White Rod End Set for Tie-Rods  [YOKBM206W]

Replacement rod ends for steering linkages

The Yokomo YOKBM206W rod end plastic parts are an RC-scale replacement for tie-rod and turnbuckle connections used in steering and suspension linkages. These white rod ends provide a low-profile ball-seat where a ball end or turnbuckle attaches, intended for general tie-rod systems rather than a specific chassis.

Made as a basic service item, the pieces restore tightness where wear and play can appear in steering linkages. Plastic rod ends trade metal hardness for quieter operation and lower cost, and they are often chosen where reduced binding and lighter weight matter. Expect typical plastic behavior: suitable wear life for hobby use and more flex compared with metal alternatives.

Installation is simple: remove the worn rod end from the turnbuckle or linkage, fit the replacement so the ball-seat engages cleanly, and confirm free movement through the full travel of the linkage. After fitting, inspect the joint for excessive play and perform a final steering centring check. Because this product fits general tie-rod and turnbuckle configurations, verify thread sizes and ball-seat type on your car before use to ensure a correct fit.

For tuning, plastic rod ends change steering compliance and feedback; switching to a stiffer material or a metal rod end is a common way to reduce flex if a sharper steering response is needed. Conversely, plastic ends can help absorb small impacts and reduce shock transfer to servos during casual running.