This 2-piece front hex hub wheel set is intended for 1/10 off-road RC use. The yellow hubs are designed for standard hex wheel interfaces and are sold as a pair to fit both front sides of the axle.
Install this part when you need a direct replacement hub or when adjusting front-end responsiveness as part of vehicle setup. The hub's hex interface is the securing point for the wheel; confirm your wheel nut and hex size match the hub before fitting.
Installation is simple for hobbyists familiar with 1/10 off-road wheel removal: remove the wheel, align the hub on the axle hex, and secure with the correct wheel nut and hardware. This text assumes basic familiarity with wheel-nut fastening and does not replace manufacturer service bulletins.
Copyright © 2008-2026 rcjaz.ca All rights reserved