Yokomo Y4-202RL Graphite Lower Slide Rack for Y4-202LW Assembly  [Y4-202RL]

Yokomo Y4-202RL Graphite Lower Slide Rack for Y4-202LW
Price:
CAD$7.18
Brand:
Yokomo
Model:
Y4-202RL
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - YD-4 category
Write a review

Graphite lower slide plate for YD-4 designs

This Y4-202RL component is the graphite lower plate that pairs with the Y4-202LW aluminium slide rack assembly on Yokomo YD-4 style setups. It is intended as an aftermarket lower slide plate where graphite material is specified in the slide rack build.

Fitment and purpose: the plate is made for DP-YD4 and DP-YD4MR chassis variants that accept the Y4-202LW slide rack. As a graphite element, it alters the slide rack's response and is used by racers and tuners to influence chassis stiffness and weight distribution during setup sessions.

Fitting notes: replace the existing lower plate in the Y4-202LW assembly with the Y4-202RL following the slide rack fastener positions; confirm correct alignment to the DP-YD4 or DP-YD4MR chassis before final tightening. Standard hobby hex drivers are sufficient for installation, and a clearance check around drivetrain and suspension parts is advised after fitting.

Compatible Models

  • DP-YD4
  • DP-YD4MR
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I install the Y4-202RL into my slide rack?

Install the Y4-202RL by removing the original lower plate from the Y4-202LW assembly and fitting the graphite plate into the same fastener locations. Ensure the plate sits flush and torque screws evenly to avoid distortion.

Will this part fit DP-YD4 and DP-YD4MR without modification?

Yes. The plate is produced to fit the Y4-202LW slide rack used on DP-YD4 and DP-YD4MR chassis types, but always verify alignment before final assembly.

Any special tools needed for fitting?

No special tools are required. Standard hex drivers used for hobby RC assembly are all that is typically needed to swap the lower plate.

Copyright © 2008-2026 rcjaz.ca All rights reserved