Yokomo MS-B60AS Hard-Coated Aluminium Suspension Ball Set for MS Series (2 sets)  [MS-B60AS]

Hard-coated aluminium ball joints for MS series

This aluminium suspension ball set is engineered to sharpen suspension response on MS-series RC cars. Each ball and holder are treated with a hard coat to resist surface wear and to keep articulation smooth through repeated use.

The balls feature a slightly larger diameter than standard parts to provide finer control over clearance and lateral play. That modest size increase helps when setting very small gaps between ball and socket during chassis setup.

Installation is simple: remove the stock ball and holder, fit the replacement assembly, set the clearance with the suspension at neutral ride height, then tighten the nut. Use the supplied dedicated 8.0mm wrench for incremental adjustments to avoid over-torquing and to protect the hard-coated finish.

For track tuning, these hard-coated aluminium balls cut down small friction variations in linkage travel, aiding chassis setups that demand consistent rebound and compression. Fit them when you want repeatable suspension geometry during step-by-step setup changes or circuit testing.

Select this set when you need low-friction, stable ball joints for precise suspension adjustments on MS-series chassis, and retain the supplied wrench for accurate tightening and maintenance.