Yokomo GT500 Front Suspension Arm Pins - YOKGT-12L  [YOKGT-12L]

GT500 Front Suspension Arm Pin Overview

This RC-scale replacement is made for the front suspension assembly of the GT500 chassis. The Yokomo YOKGT-12L front suspension arm pins hold the suspension arm pivot to the chassis and act as a direct swap when original pins are worn or broken.

Compatibility is limited to the GT500 chassis, so confirm your chassis code before buying. The pins serve as a simple pivot point; their main purpose is to keep correct arm alignment and cut down on unwanted play that can harm steering response and suspension behaviour.

Installation is simple for hobbyists with basic workshop experience: remove the damaged pin, clean the mount, then press or slide the replacement pin into place and refit any retaining clips or screws required by your chassis. Follow standard RC workshop checks and re-tighten fasteners after the first run.

Tuning tip: fitting fresh pins restores consistent arm motion and improves predictability when making small setup changes. The pins do not alter geometry on their own, but removing lateral play helps make toe and suspension adjustments more repeatable.