R12 Front Stabilizer Block Right for R12 Chassis - Yokomo R12-17R  [R12-17R]

Yokomo R12-17R Front Stabilizer Block Right for R12
Price:
CAD$6.66
Brand:
Yokomo
Model:
R12-17R
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - R12 category
Write a review

Right-side front stabilizer block for R12 chassis

This is a genuine RC-scale front stabilizer block made for the Yokomo R12 family, supplied as the right-side unit. It serves as a direct-fit replacement or optional upgrade where the R12 layout accepts separate stabilizer blocks, and it works with GT-series option setups listed below.

Function and tuning role: the block locates the stabilizer link and influences front roll resistance. Replacing the right-side block changes preload and stabilizer geometry, allowing fine-tune adjustments to understeer/oversteer balance and front-end feel through corners. Use this part when adjusting roll distribution or to replace a worn or damaged right-side mount.

Installation notes: the component mounts into the front sub-assembly at the stock block location, preserving stabilizer link alignment. Basic front-end disassembly is typically required to swap the unit; ensure correct orientation and secure fasteners to factory torque. No extra tools or hardware are included.

Compatibility

  • GT5-R35
  • GT5-SC430
  • GT3-REA
  • GT3-IS350
  • GT3-B4
  • GT3-CAX
  • GT3-BRZ
  • GT3-AHP
  • GT-B
  • GT5-R2
  • GT5-RS2
  • YR-R12C3
  • YR-R12C31
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this fit my R12 variant?

Yes. This right-side block is designed for the Yokomo R12 series and fits the listed GT and YR chassis variants shown in the compatibility list.

How does swapping the block change handling?

Changing the right-side stabilizer block alters link geometry and preload on the front anti-roll assembly, producing small but noticeable adjustments to front roll stiffness and corner entry balance.

Any special steps for installation?

Remove the front sub-assembly to access the block, install in the correct orientation, confirm link lengths, and tighten fasteners to recommended torque. Basic hand tools are sufficient.

Copyright © 2008-2026 rcjaz.ca All rights reserved