Yokomo FA-19219 FANTOM sensor board replacement for HELIX and ICON series  [FA-19219]

Price:
CAD$52.12
Brand:
Yokomo
Model:
FA-19219
GTIN:
639342200849
Condition:
Brand New
Write a review

Restore sensored feedback on FANTOM motors

This replacement sensor board is intended for the FANTOM motor family and fits motors designed for a 26mm rotor. It provides the sensor interface needed for sensored control when used with HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque motor variants. The board's role is to restore or maintain sensored feedback to the motor control system rather than change motor mechanical characteristics.

Installation requires matching the board to the motor variant and aligning connector pins to the motor harness; confirm part orientation and connector type before powering the system. Because this is a component-level replacement, inspect contacts, solder joints and the mating connectors on both motor and ESC prior to full reassembly. Use a static-safe work area and avoid bending sensor leads.

For tuning and operation, the sensor board itself does not change power output or timing settings but ensures accurate rotor position information is available to sensored ESC setups. If problems continue after fitting the board, verify ESC sensor inputs and motor timing rather than assuming a mechanical fault.

Specifications

  • Item Sensor board replacement for FANTOM motor, for 26mm rotor motors
  • Material Not specified
  • Model Number FA-19219
  • Compatibility FANTOM motors used with HELIX, HELIX V2, ICON V2, ICON V3, ICON-Torque; supported chassis FA-19113S, FA-19117S, FA-19221S, FA-19013S, FA-19017S, FA-19021S, FA-18913, FA-18917-6

Fit this Yokomo FA-19219 board when replacing a failed sensor module in a sensored FANTOM motor setup to restore reliable rotor position feedback. After swapping, run a sensor test and review ESC configuration to confirm correct operation.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I check the board orientation before powering the motor?

Visually align the connector keyed edges with the motor harness, confirm pin order against the motor wiring diagram, and perform a low-voltage continuity check with a multimeter before applying full power.

Is FA-19219 suitable for HELIX-Torque and ICON-Torque variants?

The FA-19219 is specified for FANTOM family variants listed for HELIX and ICON types; confirm the motor uses a 26mm rotor and matching connector type to ensure compatibility.

What pre-checks should I perform before reassembly?

Inspect solder joints and connector pins for corrosion or damage, verify the board mounting points, and check that sensor traces are intact. Replace any suspect wiring before closing the motor.

How can I test the sensor signals after fitting the board?

Use an ESC with a sensor-diagnostics mode or a scope to observe the three-phase sensor signals while spinning the rotor slowly; confirm consistent pulse patterns before full operation.

Are special handling precautions needed for this board?

Yes. Work in an ESD-safe area, ground yourself, avoid direct contact with exposed traces, and use fine tools for small connectors to prevent mechanical stress.

Will replacing the sensor board change motor RPM or torque?

No. The board restores position sensing only; it does not alter the motor's mechanical power or maximum speed. Any performance variance after replacement indicates ESC setup or timing issues.

Copyright © 2008-2026 rcjaz.ca All rights reserved