Yokomo DP & MRTC Deep-Rim Universal 2mm 2-Pin Drift Bone - Yokomo D-041A  [D-041A]

2mm Two-Pin Universal Drift Bone

This is an RC-scale universal bone intended for front and rear use with deep-rim universal shafts where a reinforced 2mm joint pin is required. It is meant for drift setups and is compatible with a wide range of Yokomo DP and MRTC drift chassis listed below. The piece serves as a drivetrain coupling component for model cars and should be handled as a scale hobby accessory.

Fit using the correct 2mm reinforced joint pins only. Verify pin seating and rotation clearance and confirm spline alignment before final tightening. When carrying out service, inspect the joint pins for wear and keep mating shaft surfaces clean to avoid binding in the deep-rim assembly.

Tuning note: this bone helps maintain universal shaft coupling geometry under high articulation and drift loads, supporting predictable drivetrain response and reducing slop when installed correctly in the listed chassis.