Yokomo B-MAX4 III Front Steering Plate 7075 - Arrowmax AM-MAX4-002  [AM-MAX4-002]

Front steering plate for Yokomo B-MAX4 III

This Arrowmax AM-MAX4-002 steering plate is an RC-scale replacement designed for the Yokomo B-MAX4 III chassis. Machined from 7075 aluminium, it gives greater stiffness compared with stock plates and works as a direct-fit hop-up to help preserve or fine-tune front steering geometry on touring car rigs.

The part acts as the rigid mounting point within the steering assembly, securing servo linkages and steering knuckles. By reducing flex at the pivot points it improves steering consistency and can influence toe and Ackermann behaviour during setup changes.

Fitting is straightforward for builders familiar with the B-MAX4 series: remove the original plate, transfer any bearings or bushings, and install this plate using the existing hardware and the recommended torque for aluminium fasteners. After installation check servo horn position and confirm equal linkage lengths to ensure neutral steering travel.

Fitment Details

• Yokomo B-MAX4 III

Choose this plate when you want a firmer front end or when replacing worn steering components on a B-MAX4 III; always verify fit and recheck linkage geometry when changing steering parts.