Yokomo B-MAX2/B-MAX4 Rear Knuckle Upgrade with Carbon Mounts - Arrowmax AM-MAX-015  [AM-MAX-015]

Arrowmax AM-MAX-015 Rear Knuckle Set For Yokomo B-MAX
Price:
CAD$67.66
Brand:
Arrowmax
Model:
AM-MAX-015
Condition:
Brand New
Write a review

Rear hub upgrade for Yokomo B-MAX

The Arrowmax AM-MAX-015 rear knuckle set replaces the factory plastic hubs on Yokomo B-MAX2 and B-MAX4 1/10th buggies with blue anodised metal hubs and carbon fibre camber link mounts. The kit also includes rubber-sealed ball bearings and a full hardware pack so you can swap in the metal hubs and camber mounts as a direct upgrade.

The design centres on added stiffness at the hub area plus multiple upper camber link positions for fine tuning. The six-position upper link layout lets you dial camber arm height and roll centre progression in steps, supporting setup changes without swapping other suspension pieces.

Kit contents

  • 2 pcs blue anodised rear hubs
  • Carbon fibre camber link mounts
  • Rubber-sealed ball bearings
  • Hardware set

Specifications

  • Item: Rear knuckle set
  • Material: Anodised aluminium hubs, carbon fibre camber link mounts, rubber-sealed ball bearings
  • Model Number: AM-MAX-015
  • Compatibility: Yokomo B-MAX2, Yokomo B-MAX4

Builders looking for a straightforward metal replacement with expanded setup options will find the AM-MAX-015 a compact way to stiffen the hub area and tune camber link geometry on Yokomo B-MAX buggies; use the supplied hardware and confirm bearing seating before hitting the track.

Does this fit both B-MAX2 and B-MAX4 chassis?

Yes, the AM-MAX-015 is made to be compatible with Yokomo B-MAX2 and B-MAX4 rear assemblies as a direct replacement for the stock hubs.

Are the bearings and screws included in the pack?

The kit ships with rubber-sealed ball bearings and a hardware set to allow straightforward installation into the existing suspension setup.

How do the six camber link positions change handling?

Moving the upper camber link changes the link angle and roll centre path, so you can tune camber gain and mid-corner balance incrementally without changing arms or hubs.

Any special tools needed for install?

Standard RC tools are sufficient: hex drivers, a bearing press or safe bearing driver, and thread locker for metal-to-metal fasteners if preferred.

Copyright © 2008-2026 rcjaz.ca All rights reserved