Yokomo BD11 Factory Pro O-YCP009 Graphite Rear Shock Tower  [FP-O-YCP009]

Price:
CAD$14.75
Brand:
Factory Pro
Model:
FP-O-YCP009
Condition:
Brand New
Write a review

Graphite Rear Shock Tower for Yokomo BD11

Upgrade the handling of your Yokomo BD11 with the Factory Pro O-YCP009 rear shock tower. Made from quality graphite, this replacement part enhances durability and delivers more precise response on race surfaces for drivers chasing consistent lap times.

Stiff Construction with Low Weight

The Factory Pro tower is machined from 3.0mm graphite to provide strong, reliable support while keeping mass minimal. Its flat-matt finish reduces glare and helps preserve the balance and agility of your RC car.

Engineered to Fit the BD11 Chassis

Produced to match the Yokomo BD11 mounting geometry, this shock tower fits cleanly into stock layouts. It serves as a straightforward upgrade or a direct replacement when you are tuning suspension geometry or replacing worn parts.

Will this fit other Yokomo models?

This component is made for the Yokomo BD11 and matches its mounting points. Other Yokomo models may require drilling or spacing to fit properly.

Does the graphite change weight distribution?

Graphite is light and rigid, so the O-YCP009 keeps overall weight low while adding stiffness to the rear end, which can sharpen cornering balance.

Any tips for installation and care?

Use standard hex drivers and check screw torque to avoid over-tightening. Wipe the flat-matt surface clean of grit and inspect mounting holes for wear after heavy use.

Copyright © 2008-2026 rcjaz.ca All rights reserved