YD-2 Rear Suspension Mount 38.5mm Pin Spacing - Yokomo Y2-RAC6  [Y2-RAC6]

Y2-RAC6 rear mount for YD-2 assemblies

This aluminium rear suspension mount is made to work with the YD-2 A-arm SP rear suspension kit and acts as the locating point between the rear suspension pins. The part preserves the required 38.5mm suspension pin spacing and keeps the suspension pin angle at 0 degrees, matching the Y2-RAC6 specification.

When installed it fits into the rear A-arm SP layout and is positioned in the sequence both before and after the rear suspension mount as part of the assembly. Because the suspension pin angle is fixed at 0 degrees, any rear toe correction must be achieved by altering the rear hub angle rather than rotating this mount.

The component is an aluminium machined item intended for RC chassis alignment and maintenance on compatible YD-2 platform variants, providing a direct replacement for setups that require the defined 38.5mm pin spacing.

This Y2-RAC6 aluminium rear suspension mount delivers the exact 38.5mm pin spacing and a locked 0 degree pin angle required for YD-2 A-arm SP rear assemblies, useful where precise rear geometry is required.