YD-2 Aluminum Motor Mount Upgrade Y2-304A for Yokomo  [Y2-304A]

Rigid aluminum motor bracket for YD-2 chassis

This aluminium motor mount is made as a direct-fit upgrade for the Yokomo YD-2 series of 1/10 scale drift chassis. It provides the mounting interface that secures the motor and sets offset and alignment relative to the spur/pinion or belt drive arrangement. The component is intended for model chassis use and replaces the softer factory bracket to reduce movement where the motor attaches.

Installation is straightforward on supported YD-2 variants using the existing chassis motor mount points. Because there are small differences in motor spacing and hardware between DP and MRTC variants, confirm the mount hole pattern and alignment with your specific chassis before final tightening. The aluminium part replaces the stock plastic bracket to deliver a firmer mounting location and reduced flex.

From a setup perspective this mount improves motor position stability and repeatability; a stiffer bracket helps preserve pinion-to-spur or belt alignment under high-slip drift conditions. After fitting, check gear mesh or belt tension and recheck following a short trial run to ensure alignment has remained stable.

Fit the Y2-304A when you need a firmer motor mounting point on Yokomo YD-2 platforms, verify hole positions against your chassis variant before final torque, and recheck drive mesh after initial runs.