XRAY X1'19 CNC Aluminum Rear Motor Bulkhead Right  [XR-373015]

Race-Proven Rear Motor Bulkhead from XRAY X1'19

The XRAY X1'19 Aluminum Rear Motor Bulkhead is a purposeful upgrade aimed at racers who want consistent handling and solid build quality. Machined from Swiss 7075 T6 aluminum, this component balances strength and weight while the black coating gives corrosion resistance and a neat finish.

Lightweight Geometry for Sharper Handling

Careful CNC machining removes unnecessary mass while keeping structural integrity, lowering the rear suspension center of gravity for improved cornering. The ultra-low profile and reduced weight make this bulkhead well suited to competitive track setups where responsiveness matters.

Quick, Accurate Ride Height Tuning

The bulkhead uses a shim-based system to let you fine tune ride height without removing the car. Adjustments are possible in 0.25mm increments for more precise setup steps than older 0.5mm methods, helping you dial in handling faster at the pits.

For racers seeking predictable rear-end behaviour and straightforward setup tweaks, the XRAY X1'19 Aluminum Rear Motor Bulkhead brings precise construction and easy ride height control to competitive cars.