XRAY T4-20 Graphite Front Shock Tower for Tuning - Factory Pro O-XCP001  [FP-O-XCP001]

Graphite front shock tower for XRAY T4-20

This RC-scale graphite front shock tower is made as a replacement for the XRAY T4-20 chassis and supplied under the Factory Pro O-XCP001 reference. It locates and secures the front shock absorbers while allowing changes to mounting positions that affect suspension geometry.

Use is limited to model car suspension setup and repair. Fitting this tower alters shock mount points and can influence roll centre and leverage ratios, so confirm setup changes during track testing. The graphite construction gives a typical stiffness to weight balance used in 1:10 touring car hop-ups.

Installation notes: remove the original tower following your chassis service routine, align the replacement to the same reference marks, and where possible reuse the factory mounting hardware. After fitting, check clearance near the servo and links, confirm shock shaft alignment, and tighten progressively while validating handling on short runs.