XRAY T4 Mid Chassis Plate 7075 2.0mm - Arrowmax AM-910012  [AM-910012]

Arrowmax AM-910012 AM Medius Xray T4 MID Chassis 7075 2.0mm
Price:
CAD$127.97
Brand:
Arrowmax
Model:
AM-910012
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Medius MID chassis upgrade for XRAY T4

The Arrowmax AM-910012 Medius MID chassis plate is a direct-fit aftermarket option built for XRAY T4 mid-layout touring car variants, machined from 7075 aluminum and specified at 2.0mm thickness. It is intended to increase platform rigidity compared with stock plates while retaining the MID layout geometry used on T4 series cars.

This chassis suits hobbyists focused on setup tuning and structural upgrades to XRAY T4 kits. It keeps T4 mounting patterns and is designed to use the donor chassis hardware and mounting points; pay attention to fastener alignment and torque to preserve chassis geometry during adjustments.

Specifications

  • Item AM Medius Xray T4 MID Chassis
  • Material 7075 aluminum
  • Model Number AM-910012
  • Compatibility XRAY T4
  • Thickness 2.0mm

For XRAY T4 owners aiming for a mid-layout tuning platform, the 7075 2.0mm Arrowmax AM-910012 Medius chassis offers a straightforward aluminum upgrade; always verify fit with your specific T4 variant before final installation.

Will this replace the stock T4 chassis plate?

Yes. The AM-910012 is made to match XRAY T4 MID mounting points so it can replace the stock plate, but confirm holes and standoffs on your specific T4 edition before swapping.

How does 7075 aluminum change handling?

7075 aluminum raises chassis stiffness, which can make the car feel more precise and responsive; expect changes to balance and adjust suspension settings accordingly during setup.

Do I need new screws or spacers?

Most installs use the original T4 hardware. Inspect thread engagement and check that standoffs line up; replace any worn fasteners and torque to recommended values.

Is trimming or filing required for fit?

The plate is produced to T4 dimensions so trimming is normally unnecessary, but small adjustments may be needed depending on electronics layout or optional parts you run on the car.

Copyright © 2008-2026 rcjaz.ca All rights reserved