XRAY T4 BB DJC 52mm Drive Shaft by Arrowmax AM-010084  [AM-010084]

XRAY T4 52mm replacement drive bone

This Arrowmax AM-010084 drive shaft is an RC-scale replacement part specified for the Xray T4 touring chassis, supplied as the BB DJC bone-only shaft in spring steel and 52mm length. The listing denotes the shaft only, without additional linkage or hardware components.

Use this shaft where a like-for-like swap is needed during routine maintenance or to replace a worn bone in the drivetrain. Its spring steel build is chosen for torsional durability and predictable flex under load, helping to keep power transfer consistent on a T4 chassis.

Installation notes: fit this component into the T4 drive assembly following standard bone removal procedures, check cups and pins for wear, and renew any loose fasteners or bearings to secure alignment. Perform short trial runs and small clearance checks after installation to verify free rotation and no binding under running conditions.