XRAY T4 53mm BB DJC Bearing Block Upgrade by Arrowmax AM-010071  [AM-010071]

BB DJC bearing block for XRAY T4 setups

This Arrowmax AM-010071 BB DJC accessory is a 53mm bearing block made to suit XRAY T4 chassis arrangements. It is an aftermarket RC part intended to match 53mm linkage spacing and to replace a ball joint block when the BB DJC layout is required.

The block serves a tuning purpose: it positions the ball ends, keeps correct linkage spacing, and can influence steering geometry and roll center when swapped during setup iterations. Double check that your XRAY T4 uses 53mm links before fitting to ensure correct alignment.

Fitting is straightforward for anyone experienced with T4 linkage work: remove the old block, transfer any needed studs or bearings, and tighten fasteners to your chassis specification. Standard hex drivers used for T4 maintenance are all that are required. After installation, run the steering through its full travel and confirm there is no binding and that geometry settings remain as intended.

Fit this BB DJC block when matching 53mm linkage geometry on XRAY T4 cars; treat it as a precision replacement and verify clearances and steering geometry after installation.