XRAY NT1 Titanium Turnbuckle Set XN1-39 by 3Racing  [XN1-39]

Precision turnbuckles for NT1

This turnbuckle set is designed for the XRAY NT1 chassis and serves as a suspension and steering linkage upgrade finished in titanium. It is intended as a compatible replacement for standard steel or aluminium turnbuckles; always confirm physical fitment with your NT1 ball ends and rod ends before installation.

Role in setup: adjustable turnbuckles let you fine tune toe, camber link length and some roll-center geometry on 1/10 touring car setups. Swapping to titanium-finish links gives a stable threaded connection for small adjustments and helps preserve alignment between runs.

Installation tips: match left and right thread directions to their correct locations on the NT1 chassis and use the hex driver size that fits your ball ends and rod ends. Tighten to a firm hand torque to avoid stripping threads and check full suspension and steering travel after fitting. If you replace matched-length links, work incrementally while measuring front and rear alignment changes.

Care and handling: titanium-finish parts resist corrosion better than untreated steel, but inspect threads occasionally for wear and use thread-locker sparingly where permanent fixation is needed. Keep ball ends and rod ends free of grit to reduce wear.