XRAY NT1 Rear Anti-Roll Bar Aluminium XN1-26 by 3Racing  [XN1-26]

Aluminium rear anti-roll bar for XRAY NT1

This aluminium rear stabilizer is a direct-fit replacement for the XRAY NT1 1/10 touring car chassis, supplied as model XN1-26. It is intended as a tuning component to adjust rear roll resistance and fine-tune balance between traction and rotation on paved circuits and practice sessions.

The stabilizer mounts to the NT1's factory rear sway bar posts and uses the original linkages and fasteners, so no special adaptors are required. Installation is straightforward with basic hex drivers; check existing links and hardware, fit the stabilizer onto the sway bar posts, then verify alignment and torque after a short run-in.

As a setup item, this part alters rear roll behaviour during corner entry and mid-corner. Use it alongside sway bar end-link positions and rear damper settings, and make small incremental changes to isolate its effect on handling.

Choose this aluminium rear stabilizer when you want a durable, serviceable part to refine rear roll on XRAY NT1 setups; combine with suspension tweaks for consistent cornering response.