XRAY NT1 Clutch Pinion 18T Hard Coated 7075-T6 - Arrowmax AM-NT1-338518  [AM-NT1-338518]

Arrowmax AM-NT1-338518 1st.GEAR 18T (7075 HARD)
Price:
CAD$9.07
Brand:
Arrowmax
Model:
AM-NT1-338518
Condition:
Brand New
Write a review

Arrowmax 1st Pinion for XRAY NT1

This Arrowmax 1st gear pinion is an aftermarket clutch pinion made specifically for the XRAY NT1 platform. Machined from 7075-T6 aluminium and finished with a hard coat, it is intended to replace the stock 1st gear pinion and mesh with NT1 spur gears without modification.

The available tooth counts cover common on-track tuning steps: 16T, 17T, 18T, 19T, 20T, 21T, 22T and 23T. Select different tooth counts to adjust acceleration versus top speed for your XRAY NT1 setup.

Installation notes: the pinion follows the NT1 clutch assembly form factor, so verify shaft diameter and clutch fit before final installation. When installing, set a clean gear mesh and test clutch engagement across throttle ranges to prevent premature wear.

Tuning role: swapping the 1st pinion is a simple mechanical way to alter gearing for specific track layouts or motor characteristics. Used with standard NT1 spur gears, these pinions change gearing only and do not require ESC or motor reprogramming.

Will this fit all XRAY NT1 clutch types?

The part matches the NT1 clutch pinion form factor, but you should confirm the clutch type and shaft diameter on your specific NT1 variant before purchasing.

Which tooth count should I pick for tight tracks?

Choose a lower tooth count to favour acceleration on tight, technical circuits and a higher count for better top speed on fast layouts. Consider your motor's torque and the track profile when deciding.

Do I need to change electronics after swapping pinions?

No electronic changes are required because this is a mechanical gearing change. Still monitor motor temperature and current draw after fitting a new gear to ensure safe operation.

Copyright © 2008-2026 rcjaz.ca All rights reserved