XRAY NT1 Aluminium 1st Gear Adaptor XN1-06/RE by 3Racing  [XN1-06/RE]

Lightweight aluminium 1st gear adaptor for XRAY NT1

This aluminium 1st gear adaptor is a scale RC replacement part made for owners of the XRAY NT1 chassis. Machined from aluminium, the adaptor stiffens the spur-to-pinion interface and helps preserve consistent gear meshing in 1:10 electric on-road drivetrains.

Built for NT1-spec gearboxes, the adaptor is a direct-fit hop-up that replaces the standard plastic or alloy item without altering the gearbox layout. The red anodised finish gives a clear visual reference during setup and inspections.

Installation is straightforward for experienced tuners: install the adaptor where the factory part sat using the existing fastener points, check concentricity between motor pinion and spur gear, then fine-tune backlash and mesh as part of routine setup. Note this part is intended for alignment and geartrain tuning, not major chassis modification.