XRAY 373036 - X1'19 Graphite Rear Wing Mount Plate 2.5mm  [XR-373036]

XRAY 373036 - X1\'19 Graphite Rear Wing Mount 2.5mm
Price:
CAD$26.98
Brand:
XRAY
Model:
XR-373036
Condition:
Brand New
Write a review

Graphite Wing Mount Tuned for XRAY X1'19

The XRAY 373036 - X1'19 Graphite Rear Wing Mount is built for the X1'19 chassis using 2.5mm graphite. It balances light weight with strength and gives clear mounting options so drivers can dial in wing angle and position for different grip levels. The design supports both low traction asphalt and higher grip carpet layouts, letting racers optimise handling for the surface they run on.

Tune Traction and Balance

With several mounting locations, the XRAY rear wing mount lets you shift the wing higher for more off-power stability or lower to cut traction rolling on grippier surfaces. These adjustments are practical for weekend club racing and for fine tuning balance between corner entry and mid corner grip.

Machined Strength with Cooling Options

Precision machined from quality 2.5mm graphite, the mount stays light while resisting race wear. The part also includes two extra holes for optional fan installation to help keep electronics cooler during extended runs.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this mount fit older X1 variants?

This mount is made for the X1'19 chassis and matches its wing geometry. It may require modification to fit earlier X1 versions that have different mounting points.

How do I decide wing height for asphalt?

On low traction asphalt try the higher mounting slots to increase rear grip off throttle. Start with one notch higher than your baseline and test for reduced oversteer.

Are the fan holes threaded?

The two extra holes are clearance holes for small cooling fans. Check your fan hardware for correct screw size and add appropriate fasteners if needed.

Copyright © 2008-2026 rcjaz.ca All rights reserved