XRAY 362370 Composite Inline Hub - Rear Bevel Gear Adjuster  [XR-362370]

XRAY 362370 - Composite Inline Hub For Bevel Drive Gear - Rear Hs Bulkhead - 1+2+3 Dots
Price:
CAD$15.26
Brand:
XRAY
Model:
XR-362370
Condition:
Brand New
Write a review

Fine Rear Tuning with the XRAY 362370 Composite Inline Hub

The XRAY 362370 composite inline hub is built for drivers wanting accurate rear drive setup on the XB4'21. Use this hub to adjust bevel gear alignment and height so the rear end responds more predictably during corner exit and acceleration.

Adjustable Rear Drive Layout

Made for the rear HS bulkhead on the XB4'21, this composite hub lets you change the rear differential geometry. There are six discrete height positions, letting you move the bevel drive within a 5mm span to tailor traction and roll behaviour.

Fitment and Typical Use

This part is intended for the XRAY XB4'21 line and suits racers who swap setups between carpet, asphalt and loose surfaces. Proper alignment from this hub helps reduce binding and improves overall drivetrain efficiency.

Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
The hub provides six height positions across about 5mm of total travel. Each step shifts bevel gear height to influence drivetrain angle, traction and how the rear end rolls through corners.
Installation is direct to the XB4'21 rear HS bulkhead, but check for any small hardware differences if you run aftermarket bulkheads or spacer kits.
Start in the mid setting and adjust one step at a time; lower settings tend to tighten rear traction for high-grip carpet while higher settings can help on looser dirt by reducing rear bite.

Copyright © 2008-2026 rcjaz.ca All rights reserved