XRAY 352110 Hardened Front Lower Suspension Arm for Vintage XB  [XR-352110]

XRAY 352110 Front Lower Suspension Arm - Hard
Price:
CAD$11.14
Brand:
XRAY
Model:
XR-352110
Condition:
Brand New
Write a review

Stiffen your vintage XB with XRAY 352110

The XRAY 352110 Front Lower Suspension Arm is a precision-molded composite part meant to raise the front-end stiffness of older XB series cars. Made from a hard composite, this arm improves chassis feedback and keeps steering predictable under load.

Built for rugged track use

The hard composite construction resists deformation during hard landings and high speed cornering, helping preserve suspension geometry and consistent handling through long race days.

Install left or right with ease

This arm is shaped for universal fitment on either side of the front suspension, letting tuners swap or replace parts quickly during maintenance or setup changes.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will XRAY 352110 fit all vintage XB front uprights?

It fits most older XB front upright setups, but check your chassis mounting points and hinge pin spacing before installation to confirm compatibility.

Should I pair this with stiffer shocks?

A firmer arm often works best with slightly stiffer front springs or higher damping to keep the balance between grip and response.

Any tips for avoiding premature wear?

Keep hinge pins clean, use proper hardware torque, and inspect mounting holes for play after a few runs to prevent uneven wear.

Copyright © 2008-2026 rcjaz.ca All rights reserved