XRAY 345320 61mm Rear Drive Shaft HUDY Spring Steel Upgrade  [XR-345320]

XRAY 345320 Rear Drive Shaft 61mm - HUDY Spring Steel
Price:
CAD$25.29
Brand:
XRAY
Model:
XR-345320
Condition:
Brand New
Write a review

Purpose-Built Rear Shaft for XRAY Owners

The XRAY 345320 rear drive shaft, made from HUDY Spring Steel, is a rugged upgrade for RC cars that need a dependable 61mm rear shaft. CNC machined to remove excess mass while retaining toughness, this part is made for sustained use under track conditions.

Material and Machining Quality

HUDY Spring Steel gives a balanced mix of spring and strength, helping the shaft survive hard acceleration and cornering. Precision machining and hand finishing reduce variability and support consistent drivetrain behavior across runs.

Suited to Competitive and Club Racing

Built for hobbyists who service or modify their cars frequently, this drive shaft is a straightforward swap for setups that call for a 61mm rear component and is intended to improve drivetrain reliability.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which models accept the 61mm XRAY 345320 drive shaft?

Check your vehicle manual for rear shaft length requirements; the XRAY 345320 fits 1/10 scale platforms that specify a 61mm rear drive shaft.

How should I inspect the HUDY Spring Steel shaft after a hard run?

Visually check for bends, cracks, and wear at connection points, and spin the shaft to confirm it runs true before reinstalling.

Any suggestions for break-in or installation?

Install with proper hardware torque, verify alignment, and run progressive throttle to bedding in the part under light loads before full-power laps.

Copyright © 2008-2026 rcjaz.ca All rights reserved