XRAY 343311-G Graphite Rear Upright for RX8E 2023 - Track Tuning  [XR-343311-G]

XRAY 343311-G - Composite Upright Rear For Aero Disc - Graphite
Price:
CAD$27.16
Brand:
XRAY
Model:
XR-343311-G
Condition:
Brand New
Write a review
alt="XRAY 343311-G - Composite Upright Rear For Aero Disc - Graphite" title="XRAY 343311-G - Composite Upright Rear For Aero Disc - Graphite"

Refine Rear Stability with Graphite Uprights

The XRAY 343311-G Graphite Rear Upright is designed to tighten rear-end behaviour on RX8E 2023 cars. Machined from a graphite composite, this upright helps retain accurate suspension geometry so the chassis responds consistently through corner entries and exits.

Why Graphite Composite Works Well

Graphite composite delivers a strong strength-to-weight balance favoured by racers, offering rigidity where it matters without adding unnecessary mass. That balance improves rear traction feedback and helps the suspension remain predictable under load.

Fitment Details and Quick Installation

Made specifically for the XRAY RX8E 2023 series, this rear upright drops into the existing suspension locations and can be fitted with basic RC tools. The straightforward swap lets you get back on track fast with improved rear behaviour.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the XRAY 343311-G fit older RX8E parts?

This part is intended for the RX8E 2023 geometry. Some older parts may share mounting points, but verify measurements before fitting to earlier model years.

Does it change ride height or weight significantly?

Graphite uprights are lightweight and typically cause minimal change to ride height or overall mass, making them a subtle handling tweak rather than a major weight shift.

Any special tools needed for installation?

Standard hex drivers and pliers are usually enough. Check for any threadlock or small spacer parts from the original upright and reuse them during installation.

Copyright © 2008-2025 rcjaz.ca All rights reserved