XRAY 337257 Steel Pivot Ball 8.4 mm - Rear Suspension Pair  [XR-337257]

XRAY 337257 - Steel Pivot Ball 8.4 mm (2)
Price:
CAD$25.00
Brand:
XRAY
Model:
XR-337257
Condition:
Brand New
Write a review

Precise Steering Upgrades with XRAY 337257

Fine-tune your RC car's steering with the XRAY 337257 Steel Pivot Ball 8.4mm. These hardened steel pivot balls are hand-ground for consistent wear resistance and long service life. The reduced diameter between ball and thread permits a greater steering angle, helping you carry speed through corners and improve control on exit.

Recommended for Rear Suspension Setups

These longer pivot balls are tailored for rear suspension use, allowing extra adjustment range when dialing in toe and steering geometry. Whether you race at the club or test setups at the track, they give a straightforward way to refine rear-end behaviour.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will XRAY 337257 fit my 1/10 touring car chassis?

These pivot balls suit most 1/10 scale touring and buggy rear suspensions that take 8.4 mm pivot balls. Check your arm and hub bore to confirm fitment before ordering.

How should I install and tighten these pivot balls?

Install into the suspension arm or plate per your chassis manual and tighten to the specified torque to avoid binding. A small amount of thread locker is fine if you race on rough tracks.

What maintenance keeps them working well?

Wipe off grit after runs and inspect for wear. Replace when you notice play or surface scoring to maintain predictable steering response.

Copyright © 2008-2026 rcjaz.ca All rights reserved