XRAY 305445 Kevlar Rear Drive Belt 198mm 3.6 Degree Vintage Fit  [XR-305445]

XRAY 305445 High-performance Kevlar Drive Belt Rear 3 6 Degree 198 mm
Price:
CAD$27.21
Brand:
XRAY
Model:
XR-305445
Condition:
Brand New
Write a review

Reliable Upgrade for older T Series cars

The XRAY 305445 High-performance Kevlar Drive Belt is made to improve the longevity and dependability of older T Series RC car models. At 198mm this rear drive belt gives a rugged replacement that helps keep vintage rigs running smoothly.

Advantages of Kevlar construction

Built from quality Kevlar fibres, this belt resists abrasion and stretching so it handles regular use better than standard belts. Its accurate dimensions help it mesh with existing pulleys and reduce setup time for hobbyists servicing classic machines.

Fitting and routine care

When fitting the XRAY 305445 Kevlar Drive Belt check and set the tension to prevent slipping while avoiding excess tightness. Routine inspections for fraying or flat spots will help you swap the belt before performance drops.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this belt fit all T Series generations?

This belt is aimed at older T Series releases and fits most vintage configurations that accept a 198mm rear drive belt. Check pulley spacing on your chassis to confirm fit.

How do I know when to replace the belt?

Inspect the belt for frayed fibres, glazing or uneven wear. Replace it if you notice noise, slipping or reduced throttle response to avoid drivetrain damage.

What tension should I set on installation?

Set tension so there is minimal play but without binding the pulleys. Rotate the system by hand to confirm smooth movement and recheck after short test runs.

Copyright © 2008-2026 rcjaz.ca All rights reserved