XRAY 305321 51mm Spring Steel Drive Shaft Set (Factory Kit) (2)  [XR-305321]

XRAY 305321 Drive Shaft - 51 mm - Spring Steel - (Factory Kit) (2)
Price:
CAD$73.09
Brand:
XRAY
Model:
XR-305321
Condition:
Brand New
Write a review

Service and upgrade for T Series drive shafts

Maintaining vintage T Series cars is easier with XRAY 51mm spring steel drive shafts. These factory kit parts give dependable durability so older cars keep performing across club tracks and street practice sessions.

Built for long lasting strength

Made from spring steel, the drive shafts resist wear and bending under frequent use. Their tough construction reduces maintenance and helps keep driveline play to a minimum during spirited driving.

Designed to suit older T Series layouts

These shafts are made to match older T Series mounting points and lengths, allowing a straightforward swap with minimal setup changes. That means you can refresh a vintage car without reworking the chassis.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these fit my older T Series model?

They are intended for older T Series variants and will fit when your car uses the same 51mm drive shaft length. Check your parts list or measure the original shafts to confirm.

Are any special tools needed to install them?

Basic RC tools such as a small hex driver and needle nose pliers are usually enough. No special presses are required for a standard replacement.

How should I maintain these drive shafts?

Keep them clean and check for wear at the joints and splines. Light oil on pivot points and occasional inspection will extend service life.

Copyright © 2008-2026 rcjaz.ca All rights reserved