XB8'26 / XB8E'26 Composite Rear Brace Holder XRAY 353021  [XR-353021]

XRAY 353021 - Composite Rear Brace Holder With Two Assembly Positions
Price:
CAD$19.89
Brand:
XRAY
Model:
XR-353021
Condition:
Brand New
Write a review

Rear brace holder overview

This composite rear brace holder offers two assembly positions so it fits both XB8'26 and XB8E'26 chassis layouts, providing correct rear chassis brace placement while preserving the intended handling balance.

The two-position layout allows you to orient the holder to match your motor mount and frame arrangement, keeping the brace alignment true to the original geometry. The component is an RC-grade composite part designed to give steady support during regular off-road running.

Installation is simple: remove the factory rear brace interface and fit this holder, selecting the position that corresponds to your XB8 or XB8E configuration. Verify mounting point alignment before fully tightening to avoid preload on the brace that could influence suspension feedback.

Tuning role: the holder is a mechanical alignment and support item; it does not alter suspension geometry directly but helps maintain predictable rear chassis behavior by stabilizing the brace location. Use it when converting between XB8'26 and XB8E'26 setups or to replace worn mounts that allow rear brace play.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I install this in the two positions?

Remove the stock brace interface, pick the orientation that matches your motor mount and chassis layout, then fit and torque fasteners evenly to avoid twisting the brace.

Will fitting this holder affect handling?

You should not see major handling changes; the part preserves correct brace placement so handling remains consistent when swapping between the two chassis formats.

What should I check after installation?

Inspect the mounting faces for even contact, confirm fasteners are secure, and run a quick suspension check to ensure no preload was introduced to the brace.

Copyright © 2008-2026 rcjaz.ca All rights reserved