Walkera Tail Stabilizer Paddle for 4#3B/4#3Q/4G3 - KSPB001 by K&S  [KSPB001]

Replacement tail stabilizer paddle for Walkera helis

This stabilizer paddle is an RC-scale spare intended for Walkera helicopters that specify compatibility with the 4#3B, 4#3Q and 4G3 model codes. It replaces worn or broken tail paddles to help restore proper tail rotor balance and permit precise tail-trim adjustments during preflight setup.

Fitment depends on the model codes shown in the product name; confirm those identifiers before ordering. To install, remove the damaged paddle from the tail rotor hub and fit the new paddle so it sits flush and symmetric with the opposite side. After installation, check tail rotor tracking and perform hover checks to verify neutral tail response.

When tuning, make only small alignment changes since minor shifts can noticeably affect yaw stability; test hover responses after each tweak. This paddle is an RC accessory for model maintenance and tuning and is not intended for full-scale aviation applications.