Walkera HM-4#3B-Z-04 Flybar Connector - Replacement Stabiliser for 4#3B Helicopters  [HM-4#3B-Z-04]

Walkera (HM-4#3B-Z-04) Flybar connector
Price:
CAD$0.67CAD$2.00
Brand:
Walkera
Model:
HM-4#3B-Z-04
Condition:
Brand New
Available in warehouse
Write a review

Precision flybar connector for steady 4#3B flight

The Walkera HM-4#3B-Z-04 Flybar Connector is a key replacement part made for the 4#3B helicopter family. It helps maintain balance and predictable rotor response, manufactured to resist wear and deliver consistent service life. Ideal for routine maintenance or part swaps, this connector supports smoother cyclic and collective control to keep your model flying true.

Will this connector fit other Walkera helicopter models?

This connector is designed specifically for the Walkera 4#3B series and is unlikely to match the linkage geometry of different models without modification. Always compare part numbers before fitting.

What basic tools do I need to replace the flybar connector?

Typical RC hand tools such as small hex drivers, needle-nose pliers and a screwdriver are usually sufficient. Work on a clean bench and follow safe rotor head handling practices.

Can a worn connector affect trimming and stability?

Yes. Excess play or damage in the flybar connector can change flybar geometry and lead to trim drift or vibration. Replacing with the correct Walkera HM-4#3B-Z-04 restores intended handling.

Copyright © 2008-2025 rcjaz.ca All rights reserved